Welding a Bit into the Type M Axe

Flat Feature Welding

I just welded a large, finely-layered, shear-steel bit into the Type M axe I have been working on. These pictures show the bit after it was fixed into a cleft in the wrought-iron axe body, then again after the welding was done. The edge is a little over 8″ long.


2 Responses to “Welding a Bit into the Type M Axe”

  1. Will McAlister 23. Apr, 2014 at 4:10 pm #

    Jim, I admire your skills and work. Thank you for publishing your build pictures. Your friend, Will McAlister.

    • jaustin 23. Apr, 2014 at 5:30 pm #

      Thanks for encouragement Will!

Leave a Reply